Más productos:
Tabla de contenido
La batería LiFePO4200 unidades de 24 V y 20 Ah está lista para ser probada por un cliente alemán
1.Características de la batería LiFePO424 V y 20 Ah
Lithium iron phosphate batteries are a common choice for solar street lights because of their high energy density, long life, and good stability. Among them, a Batería LiFePO4 de 24V y 30Ah is a battery that is very suitable for solar street lighting applications. For this 24V 30Ah LiFePO4 Battery, it has the advantages of high energy density and long life, which can meet the needs of long-term use of solar street lights. In addition, the safety performance of this battery is also very good, which can ensure that it will not cause fire or explosion hazards under abnormal conditions.In practical applications, solar street lamps usually use multiple such batteries to form a battery pack to meet their required power requirements. These battery packs are usually connected with solar panels, and the solar energy is converted into electrical energy through photovoltaic conversion for charging, so as to meet the electrical energy required for street lighting at night. At the same time, the battery pack of solar street lights is usually equipped with an intelligent controller to realize the charge and discharge management of the battery. These controllers can automatically adjust the charge and discharge state of the battery to prolong the battery life and improve its performance.
2. Pruebe la batería LiFePO424 V y 20 Ah antes del envío
In order to ensure the quality and performance of the battery, Batería varonil will conduct a rigorous test on the product before each shipment. The test will cover the following aspects:2.1 Testers usually measure the open circuit voltage of the battery, which is the voltage measured without any load. For this 25.6V 30Ah battery, the open circuit voltage should be around 26V. If the measured value does not match the specification, there may be a defect or problem with the battery.2.2 Testers usually conduct a capacity test to ensure that the actual capacity of the battery meets the specifications. This is usually done by placing the battery in a specific test device and discharging it at a specific rate. For this battery, the capacity should be around 30Ah. If the actual capacity is lower than the specification, the battery may be defective or have aging problems.2.3 After capacity test, cycle life test is also necessary. Cycle life refers to how many complete charge and discharge cycles a battery can perform while maintaining its specified capacity. This test is usually performed under conditions such as high temperature, low temperature and rapid charge and discharge. If the battery can survive these tests, then it meets the requirements of the application.2.4 In addition, the safety performance of the battery needs to be tested. This includes whether the battery will explode or catch fire under abnormal conditions such as overcharge, overdischarge and short circuit. To conduct these tests, testers usually use specific test equipment and test procedures, and test the battery multiple times to ensure its safe performance.2.5 The tester also needs to conduct a visual inspection of the battery to ensure that there is no physical damage or other defects. If there are obvious defects in the appearance of the battery, it may affect its performance and safety.Through these tests, we can ensure that the Batería LiFePO4 de 24V y 30Ah supplied to customers is safe and reliable. At the same time, we will also provide various certificates according to customer needs to ensure the quality of the battery and the unimpeded transportation.
